Instructions for Using THE ORIGINAL UNISEAL

- Cut hole to the holesaw size indicated for the UNISEAL you are using. (See table below.) Example: 2" UNISEAL = 3" Hole (Holesaw).
- A clean cut is essential to ensuring a leak free installation, we like to use a fine grit sandpaper. You only want to remove the burrs.
- Place the UNISEAL into the hole with the flange (wide side) facing the pipe to be inserted.
- Be sure that all burrs are removed from the pipe, a slight bevel on the end of the pipe will ease installation.
- Lubricate the outside of the pipe to be inserted with water, soap etc , push the pipe through from the
flange side of the uniseal. The uniseal will expand in the hole as the pipe is inserted creating the seal.
Specifications of Standard Sizes of Uniseals
Part #
Size Pipe ID Pipe OD Hole saw
Inch mm Inch mm Inch mm Inch
U018 3/16 4 0.150 6 0.250 8 0.3
U025 1/4 6 0.250 8 0.312 12.7 1/2
U0312 5/16 8 0.312 10 0.375 12.7 1/2
U038 3/8 9 0.375 17 0.675 25.4 1
U050 1/2 12.7 0.500 21 0.840 31.7 1.25
U075 3/4 19 0.750 27 1.050 31.7 1.25
U100 1 25 1.000 33 1.315 44.4 1.75
U125 1-1/4 31.75 1.250 42 1.660 50.8 2
U150 1-1/2 38 1.500 48 1.900 63.5 2.5
U200 2 50 2.000 60 2.375 76.2 3
U200-35 2 50 2.000 55 2.160 76.2 3
U254 2.54 64 2.540 69 2.710 101 4
U275 2.75 70 2.75 74 2.913 101 4
U300 3 76 3.000 89 3.500 101 4
U400-35 4 101 4.000 109 4.290 127 5
U400 4 101 4.000 114 4.500 127 5
U600-35 6 152 6.000 160 6.290 177.8 7
U600 6 152 6.000 168 6.500 177.8 7
Tolerances +/- 0.032 + 1mm +/- 0.062 1.5mm